Card, Adapter Card, and Port Command Reference
Page 88 7705 SAR OS Interface Configuration Guide
General Port Commands
port
Syntax port {port-id | bundle-id}
no port {port-id | bundle-id}
Context config
Description This command enables access to the context to configure ports, multilink bundles, and IMA groups.
Before a port can be configured, the chassis slot must be provisioned with a valid card type and the
adapter card slot must be provisioned with a valid adapter card type. (See the
card and mda
commands.)
Default None
Parameters port-id — specifies the physical port ID in the slot/mda/port format
bundle-id — specifies the multilink bundle to be associated with this IP interface. The command
syntax must be configured as follows:
Syntax: bundle-type-slot/mda.bundle-num
bundle[-ppp]-slot/mda.bundle-num (Creates a multilink PPP bundle)
bundle-ima-slot/mda.bundle-num (Creates an IMA group)
bundle: keyword
slot: card/adapter card slot numbers
bundle-num: 1 to 16 (up to 8 for MLPPP and IMA)
For example:
router1>config# port bundle-1/1.1 (multilink PPP bundle)
router1>config# port bundle-ima-1/1.2 (IMA group bundle)
ddm-events
Syntax [no] ddm-events
Context port {port-id | bundle-id}
Description This command enables or disables digital diagnostic monitoring (DDM) events for the port. DDM is
supported on Ethernet SFP ports and OC3 SONET SFP ports.
Default no ddm-events
To Next Page
Loading...
