Card, Adapter Card, and Port Command Reference
Page 148 7705 SAR OS Interface Configuration Guide
Output Port Output — The following tables describe port output fields:
• Table 12: "Show General Port Output Fields"
• Table 13: "Show Port Count Output Fields"
• Table 14: "Show Specific Port Output Fields (SONET/SDH Port)"
• Table 15: "Show Specific Port Output Fields (Ethernet Port)"
• Table 16: "Show Port Detail Output Fields (SONET/SDH Port)"
• Table 17: "Show Port Detail Output Fields (Ethernet - Access Mode)"
• Table 18: "Show Port Detail Output Fields (TDM DS1 Interface)"
• Table 19: "Show Port Channel Group Output Fields"
• Table 20: "Show Port ACR Detail Output Fields"
• Table 21: "Show Port Descriptions Output Fields"
• Table 22: "Show Port Associations Output Fields"
• Table 23: "Show Port PPP Output Fields"
Table 12: Show General Port Output Fields
Label Description
Port ID The port ID configured or displayed in the slot/mda/port format
Admin State Up — the administrative state is up
Down — the administrative state is down
Link Yes — a physical link is present
No — a physical link is not present
Port State Up — the port is physically present and has a physical link
Down — the port is physically present but does not have a link
Ghost — the port is not physically present
None — the port is in its initial creation state or about to be deleted
Link Up — the port is physically present and has a physical link.
When Link Up appears at the lowest level of a TDM tributary, it means
the physical connection is active but the port is waiting before data traffic
can flow. It is a waiting state and indicates that data traffic will not flow
until it transitions to the Up state.
Link Down — the port is physically present but does not have a link
Cfg MTU The configured MTU
Oper MTU The negotiated size of the largest packet that can be sent on the port or
channel specified in octets
To Next Page
Loading...
