Alcatel-Lucent 7705 - Installation Locations

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 71
Ethernet Commands
config
— [no] port {port-id}
— ethernet
— autonegotiate [limited]
— [no] autonegotiate
— dot1q-etype 0x0600 to 0xffff
—no dot1q-etype
— duplex {full | half}
— efm-oam
— [no] accept-remote-loopback
— mode {active | passive}
— [no] shutdown
— [no] transmit-interval interval [multiplier multiplier]
— [no] tunneling
— egress-rate sub-rate
—no egress-rate
— encap-type {dot1q | null}
—no encap-type
— hold-time [up hold-time-up | down hold-time-down]
—no hold-time
— mac ieee-address
—no mac
— mode {access | network}
—no mode
— mtu mtu-bytes
—no mtu
— network
— queue-policy name
— [no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [high-ber]
— speed {10 | 100 | 1000}