Card, Adapter Card, and Port Command Reference
Page 84 7705 SAR OS Interface Configuration Guide
Adapter Card Commands
mda
Syntax mda mda-slot
no mda mda-slot
Context config>card
Description This mandatory command enables access to a card’s MDA CLI context to configure adapter cards.
Default None
Parameters mda-slot — the adapter card slot number to be configured
Values 1 to 6
mda-type
Syntax mda-type mda-type
no mda-type
Context config>card>mda
Description This mandatory command provisions a specific adapter card type to the device configuration for the
slot. The adapter card can be preprovisioned, but it must be provisioned before ports can be
configured. Ports can be configured once the adapter card is properly provisioned.
A maximum of six 16-port T1/E1 ASAP Adapter cards, 8-port Ethernet Adapter cards, or 4-port
OC3/STM1 Clear Channel Adapter cards can be installed in a 7705 SAR chassis. Only one adapter
card can be provisioned per MDA slot. To modify an MDA slot, shut down all port associations.
A medium severity alarm is generated if an adapter card is inserted that does not match the adapter
card type configured for the slot. This alarm is cleared when the correct adapter card is inserted or the
configuration is modified. A high severity alarm is raised if an administratively enabled adapter card
is removed from the chassis. This alarm is cleared if either the correct adapter card type is inserted or
the configuration is modified. A low severity trap is issued if an administratively disabled adapter
card is removed.
An alarm is raised if partial or complete adapter card failure is detected. The alarm is cleared when the
error condition ceases.
The no form of this command deletes the adapter card from the configuration. The adapter card must
be administratively shut down before it can be deleted from the configuration. Before an adapter card
can be shut down, all port associations with this adapter card, for example SAPs and IP interfaces,
must be shut down first.
To Next Page
Loading...
