7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 85
fabric-stats-enabled
Syntax [no] fabric-stats-enabled
Context config>card>mda
Description This command enables the fabric port statistics counter to count egress traffic toward a specified
adapter card. The CSM allows the collection of fabric statistics from only one fabric port at any given
time.
To change the port statistics counter to a different adapter card, turn off statistics collection on the
assigned adapter card by using no fabric-stats-enabled and then enabling statistics collection on
another adapter card.
clock mode
Syntax clock mode adaptive
Context config>card>mda
Description This command defines the clocking mode on the T1/E1 ASAP Adapter card. In Release 2.0 of the
7705 SAR, clocking mode configuration is only supported on the T1/E1 Adapter card and only
adaptive mode is supported.
Default adaptive
sync-e
Syntax sync-e
no sync-e
Context config>card>mda
Description This command enables Synchronous Ethernet on the 8-port Ethernet v2 Adapter card and on optical
SFP ports on the 7705 SAR-F. When Synchronous Ethernet is enabled, the transmit timing of all
optical SFPs that support synchronous Ethernet is derived from the node’s SSU. Additionally, these
SFP ports can be used to provide timing for the SSU. When Synchronous Ethernet is disabled, the
optical SFP ports are timed from a local oscillator. Refer to the 7705 SAR OS Basic System
Configuration Guide for more information about Synchronous Ethernet.
Default no sync-e
To Next Page
Loading...
