Alcatel-Lucent 7705 - RJ-45 Distribution Panel

Common Configuration Tasks
Page 54 7705 SAR OS Interface Configuration Guide
Configuring Ethernet Port Parameters
Use the following CLI syntax to configure Ethernet network and access port parameters.
CLI Syntax: config# port port-id
ethernet
autonegotiate limited
dot1q-etype 0x0600 to 0xffff
duplex {full|half}
efm-oam
[no]accept-remote-loopback
mode {active|passive}
[no]shutdown
[no]transmit-interval interval [multiplier
multiplier]
[no]tunneling
egress-rate sub-rate
encap-type {dot1q|null}
hold-time hold-time [up hold-time-up | down
hold-time-down]
mac ieee-address
mode {access|network}
mtu mtu-bytes
network
queue-policy name
report-alarm [signal-fail] [remote] [local] [no-
frame-lock] [high-ber]
speed {10|100|1000}
Ethernet Network Port
A network port is network facing and participates in the service provider transport or
infrastructure network processes.
Use the following basic CLI syntax to configure Ethernet network mode port parameters.
CLI Syntax: port port-id
ethernet
mode {access | network}
network
queue-policy name