Alcatel-Lucent 7705 - V.35 Distribution Panel

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 55
The following CLI syntax shows an example of configuring an Ethernet port for network
mode.
Example: config# port 1/1/1
config>port# description "Ethernet network port"
config>port# ethernet
config>port>ethernet# mode network
config>port>ethernet# exit
config>port># no shutdown
Use the config port info command to display port configuration information.
ALU-B>config>port# info
----------------------------------------------
description "Ethernet network port"
ethernet
exit
no shutdown
----------------------------------------------
ALU-B>config>port#
Ethernet Access Port
Services are configured on access ports used for customer-facing traffic. If a Service Access
Point (SAP) is to be configured on a port, it must be configured for access mode. When a
port is configured for access mode, the appropriate encapsulation type can be specified to
distinguish the services on the port. Once a port has been configured for access mode,
multiple services may be configured on the port.
Use the following basic CLI syntax to configure Ethernet access mode port parameters
CLI Syntax: port port-id
mode {access | network}
encap-type {dot1q | null}
The following CLI syntax shows an example of configuring an Ethernet port for access
mode.
Example: config# port 1/1/2
config>port# description "Ethernet access port"
config>port# ethernet
config>port>ethernet# mode access
config>port>ethernet# encap-type dot1q
config>port>ethernet# exit
config>port# no shutdown