7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 155
Configured
Address
The base chassis Ethernet MAC address
Hardware Address The interface's hardware or system assigned MAC address at its
protocol sub-layer
Cfg Alarm The type of alarms to be logged and reported for the Ethernet port
Alarm Status The current alarm state
Oper Speed The operating speed of the interface
Config Speed The configured speed of the interface
Oper Duplex Full — the link is operating at full duplex mode
Half — the link is operating at half duplex mode
Config Duplex Full — the link is set at full duplex mode
Half — the link is set at half duplex mode
MTU The size of the largest packet that can be sent/received on the Ethernet
physical interface, specified in octets
Hold time up The link-up dampening time in seconds
Hold time down The link-down dampening time in seconds
Encap Type Null — ingress frames will not use any tags or labels to delineate a
service
dot1q — ingress frames carry 802.1Q tags where each tag signifies a
different service
Egr. Pool % Rate The amount of egress buffer space, expressed as a percentage of the
available buffer space, that will be allocated to the port or channel for
egress buffering
MDI/MDX Ethernet type
Ingress Rate The maximum amount of ingress bandwidth (in kilobits per second)
that this Ethernet interface can generate
Traffic Statistics
Octets
Input/Output
The total number of octets received and transmitted on the port
Table 15: Show Specific Port Output Fields (Ethernet Port) (Continued)
Label Description
To Next Page
Loading...
