Alcatel-Lucent 7705 - Notes on 7705 SAR-8 and 7705 SAR-F

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 59
no trace-string
[no] report-alarm [loc] [lais] [lrdi][lb2er-sd]
[lb2er-sf] [slof][slos] [lrei]
section-trace {increment-z0 | byte value | string
string}
speed {oc3}
no speed
threshold {ber-sd | ber-sf} rate threshold
SONET/SDH Access Port
Use the following CLI syntax to configure a SONET/SDH access port.
CLI Syntax: port {port-id}
sonet-sdh
path [sonet-sdh-index]
encap-type {atm}
[no] shutdown
The following CLI syntax shows an example of configuring a SONET/SDH port.
Example: config# port 1/1/3
config>port# sonet-sdh
config>port>sonet-sdh# path
config>port>sonet-sdh>path# encap-type atm
config>port>sonet-sdh>path# no shutdown
config>port>sonet-sdh>path# exit
config>port>sonet-sdh# exit
config>port# exit
config#
Use the config info command to display port configuration information.
ALU-B>config>info
....
#--------------------------------------------------
echo "Port Configuration"
#--------------------------------------------------
port 1/1/3
sonet-sdh
path
encap-type atm
no shutdown
exit
exit
----------------------------------------------