Alcatel-Lucent 7705 - Page 92

Card, Adapter Card, and Port Command Reference
Page 92 7705 SAR OS Interface Configuration Guide
tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
Description This command enables EFM OAM PDU tunneling. OAM PDU tunneling is required when a
loopback is initiated from a router end and needs to be transported over the existing network
infrastructure to the other end. Enabling tunneling will allow the PDUs to be mapped to Epipes so that
the OAM frames can be tunneled over MPLS to the far end.
The no form of the command disables tunneling.
egress-rate
Syntax egress-rate sub-rate
no egress-rate
Context config>port>ethernet
Description This command configures the rate of traffic leaving the network.
The no form of this command returns the value to the default.
Default no egress-rate
Parameters sub-rate — the egress rate in kb/s
Values 1 to 10000000 kb/s
encap-type
Syntax encap-type {dot1q | null}
no encap-type
Context config>port>ethernet
Description This command configures the encapsulation method used to distinguish customer traffic on an
Ethernet access port or different VLANs on a network port.
The no form of this command restores the default.
See also
dot1q-etype for information on IEEE 802.1q tagging and encapsulation.
Default
null
Parameters dot1q — ingress frames carry 802.1Q tags where each tag signifies a different service
null — ingress frames will not use any tags to delineate a service. As a result, only one service can be
configured on a port with a null encapsulation type.