Alcatel-Lucent 7705 - Installing the Components; In This Chapter

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 95
Parameters mtu-bytes — sets the maximum allowable size of the MTU, expressed as an integer
Values 512 to 1572 bytes
(see the following table)
report-alarm
Syntax [no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [high-ber]
Context config>port>ethernet
Description This command specifies when and if to generate alarms and alarm clear notifications for this port.
Parameters signal-fail — reports an Ethernet signal lost alarm
remote — reports remote faults
local — reports local faults
no-frame-lock — reports a “not locked on the ethernet framing sequence” alarm
high-ber — reports a high bit error rate alarm
speed
Syntax speed {10 | 100 | 1000}
Context config>port>ethernet
Description This command configures the port speed of an Ethernet port when autonegotiation is disabled.
Setting the speed turns off autonegotiation.
Default
100
Parameters 10 — sets the link to 10 Mb/s speed
100 — sets the link to 100 Mb/s speed
1000 — sets the link to 1000 Mb/s speed (only supported on GigE SFPs)
Type Mode Encap Type Default
(Bytes)
Max MTU (bytes)
10/100 Ethernet Access/Network null 1514 1514 (access)
1572 (network)
10/100 Ethernet Access/Network dot1q 1518 1518 (access)
1572 (network)
GigE SFP Access/Network null 1572 1572
GigE SFP Access/Network dot1q 1572 1572