Alcatel-Lucent 7750 - Page 474

Interfaces
Page 474 7750 SR Interface Configuration Guide
Parameters frf16-link--id-string — Specifies the bundle ID string.
Values 50 chars maximum
lmi-type
Syntax lmi-type {ansi | itu | none | rev1}
no lmi-type
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command configures the Local Management Interface (LMI) type for Frame Relay interfaces. LMIs are
sets of enhancements to the basic Frame Relay specification.
The no form of this command changes the LMI type back to the default value.
Default itu
Parameters ansi — Use ANSI T1.617 Annex D.
itu — Use ITU-T Q933 Annex A.
none — Disable Frame Relay LMI on the given port/channel.
rev1 — Use the Rev 1 version of ANSI T1.617 Annex D.
mode
Syntax mode {dce | dte | bidir}
Context config>port>sonet-sdh>path>frame-relay
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
Description This command sets the Frame Relay interface into the DCE, DTE, or Bidirectional mode of LMI operation.
The DTE mode causes the router to send status enquiries over the interface. The DCE mode causes the
router to respond to status enquiries. In bidirectional mode, the router performs both DTE and DCE opera-
tion over the FR interface. The bidirectional mode applies to the ANSI and ITU LMI types only.
This feature is used when two routers are connected back-to-back, running frame relay encapsulation.
Default dte
Parameters dce — Enables the DCE mode.
dte — Enables the DTE mode.