Alcatel-Lucent 7750 - Page 735

Interface Configuration
7750 SR Interface Configuration Guide Page 735
Output LAG Output — The following table describes LAG output fields.
Sample Output
A:ALA-48>config# show lag
===============================================================================
Lag Data
===============================================================================
Lag-id Adm Opr Port-Threshold Up-Link-Count MC Act/Stdby
-------------------------------------------------------------------------------
1 up down 0 0 N/A
2 up up 0 1 active
3 up down 0 0 standby
4 up down 0 0 standby
10 up down 0 0 N/A
-------------------------------------------------------------------------------
Total Lag-ids: 5 Single Chassis: 2 MC Act: 1 MC Stdby: 2
===============================================================================
A:ALA-48>config# show lag
A:sr7- show lag 10 port
===============================================================================
Lag Port States
LACP Status: e - Enabled, d - Disabled
===============================================================================
Lag-id Port-id Adm Act/Stdby Opr Primary Sub-group Forced Priority
-------------------------------------------------------------------------------
10(e) 1/1/8 up active up yes 1 - 32768
1/1/9 up standby down 2 - 32768
===============================================================================
Detailed LAG Output — The following table describes detailed LAG output fields. The output is
dependent on whether or not the LAG was configurd as a multi-chassis LAG.
Label Description
LAG ID
The LAG or multi-link bundle ID that the port is assigned to.
Adm Up — The LAG is administratively up.
Down — The LAG is administratively down.
Opr Up — The LAG is operationally up.
Down — The LAG is operationally down.
Port-Threshold The number of operational links for the LAG at or below which the
configured action will be invoked.
Up-Link-Count The number of ports that are physically present and have physical links
present.
MC Act/Stdby Member port is selected as active or standby link.