Interfaces
Page 736 7750 SR Interface Configuration Guide
Detailed LAG Output Fields
Label Description
LAG ID
The LAG or multi-link trunk (MLT) that the port is assigned to.
Adm
Up — The LAG is administratively up.
Down — The LAG is administratively down.
Port Threshold
If the number of available links is equal or below this number, the
threshold action is executed.
Thres. Last
Cleared
The last time that keepalive stats were cleared.
Dynamic Cost
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
Configured
Address
The base chassis Ethernet MAC address.
Hardware Address
The hardware address.
Hold-Time Down
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
LACP
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP Transmit
Intvl
LACP timeout signalled to peer.
Selection Crite-
ria
Configured subgroup selection criteria.
MUX control
Configured type of multiplexing machine control used in a LAG with
LACP in active/passive modes.
coupled — TX and RX activate together.
independent — RX activates independent of TX.
Number of sub-
groups
Total subgroups in LAG.
System ID
System ID used by actor in LACP messages.
Admin Key
Configured LAG key.
Oper Key
Key used by actor in LACP messages.
System Priority
System priority used by actor in LACP messages.
Prtr System ID
System ID used by partner in LACP messages.
Prtr Oper Key
Key used by partner in LACP messages.
Prtr System Pri-
ority
System priority used by partner in LACP messages.
To Next Page
Loading...
