3 Maintain the ATCA Subrack
10. Tighten both face plate screws on the JAXSSW.
11. Wait until the blue LEDs of both the front blade and the JAXSSW are OFF.
A switched OFF blue LED indicates that the payload of the respective blade
or JAXSSW has been powered up and is active.
12. Connect the Ethernet cable between LMT to the operational JAXSSW on
port 8.The IP address for LMT is 172.x.0.251 where:
x is 17 if the replaced JBXSSW is JBXSSW2
x is 18 if the replaced JBXSSW is JBXSSW1.
13. Open a telnet session on the active JBXOMCP
# telnet 172.t.y.x
where:
t is 17 if the replaced JBXSSW is JBXSSW1
t is 18 if the replaced JBXSSW is JBXSSW2
y is 3 for ATCA shelf 3
y is 4 for ATCA shelf 4
x is 30 for JBXOMCP1
x is 40 for JBXOMCP2.
14. Configure the VLAN of the new JBXSSW
root@OMCP_x:~# cd /root
root@OMCP_x:./mx_setVlan -fs SSWx
where:
x is 1, if SSW1 was replaced
x is 2, if SSW2 was replaced.
15. The VLAN configuration is finished when the following message is displayed
SSWx F300 Vlan configuration done and persisted.
VLAN configuration is also displayed.
16. Close the terminal window.
17. Connect all the cables to the JAXSSW in the initial position.
3.6.3 Replace JAXSMM
Prerequisites: The following prerequisites must be available in order to
perform the scenario:
Screwdriver
Wrist strap.
The two Shelf Manager Cards slots, located on the right side of the PEMs,
are numbered from 1 on the right to 2 on the left on the back side of each
side of the subrack chassis.
3BK 21281 AAAA PCZZA Ed.13
53 / 90
To Next Page
Loading...
