6 Software Procedures
6.4 Tool collecting On-Demand Traces/Logs
The script is under /common/bsc/SCPRDISK/,named TCKN????.??? (the
????.???is according the package release). Only the one on the active
OMCP can be launched.
The script has following phases:
Backup/Restore/Stop Trace Selection (Section 6.4.1)
Get Start/End Time of Trace Collection Period (Section 6.4.2)
Get Problem Type: (OAM, CS, PS, ATRUNK) (Section 6.4.3)
Get telecom trace collect period/id (For CS, PS, ATRUNK only) (Section
6.4.4)
Send telecom trace config to TRF Master (For CS, PS, ATRUNK only)
(Section 6.4.5)
Wait enough time for telecom trace collection (For CS, PS, ATRUNK only)
(Section 6.4.6)
Trigger all VCE to dump the remaining trace (Section 6.4.7)
Wait enough time for trace dumped to disk (Section 6.4.8)
Get trace files from CCP boards (Section 6.4.9)
Clean secure disk space & move required trace data into it on both OMCP
(Section 6.4.10)
6.4.1 Backup/Restore/Stop Trace Selection
The script will prompt a message for operator to make a selection:
Backup/Restore/Stop trace [B/R/S]
If the operator select backup, the script will go through steps 6.4.2 to 6.4.9.
If the operator selects restore, the script restores all trace data in the secure
space back to their original place. Restore function helps the operator to
restore all secured data back to their original place. With this function, the
operator can undo the previous trace backup command. If the partition disk
usage is more than 50%, no restore is done on the disk.
If the operator selects stop trace, the script sends Message C to the TRF
Master and exit immidately.
The trace data includes following items:
Realtime Trace
MXPF Trace/logs
DLS
Core files
BSC Version
MXPF Version
Patch Names
3BK 21281 AAAA PCZZA Ed.13
87 / 90
To Next Page
Loading...
