3 Maintain the ATCA Subrack
The following figure shows the location of the rotary switches on JAXPC board.
Figure 17: JAXPC: Shelf Geographic Address Rotary Switches
3.6.1.1 Remove JAXPC
To remove the JAXPC:
1. Identify the board to be replaced. Refer to Board/Area/Slot/SBL Mapping
(Section 1.3) for details.
2. Set the handle toggle switch to the "Open" position.
The blue H/S LED will flash and then turn on steadily.
Wait until the blue LED is permanently lit.
3. Unfasten the front plate screws.
4. Remove the board from the shelf using the ejector ring.
48 / 90
3BK 21281 AAAA PCZZA Ed.13
To Next Page
Loading...
