3 Maintain the ATCA Subrack
{SHELF_MANAGMENT_CONTROLLER,9},
ATCA-M100
12. Reboot the replacement JAXSMM:
hpireset3 -r <Resource>
reset resource <Resource>: rv = 0
where Resource is given in bold by the output in the previous step as follows:
First resource number (30 in the given example) is for the active JAXSMM
Second resource number (58 in the given example) is for the standby
JAXSMM.
13. Check the shelf address:
hpishaddr <Shelf Geographical Address>
03 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00
shelf address: <Shelf Geographical Address>
shelf entity path:
{RACK,0}{ADVANCEDTCA_CHASSIS,<Shelf Geographical
Address>}
where the Shelf Geographical Address is:
3 for shelf 3
4 for shelf 4
14. Close the telnet session.
3.6.4 Replace JBXPS
−
(POWER)
ON
I
O
OFF
+(RETURN)
H/S
handle
closed
open
OOS
OK
Rev. Power
PEM handle switch
Hot Swat LED
OSS (Out Of Service) LED
Power LED
Operating Voltage−44VDC to−72VDC
Maximum Current 50A
Torque Nut 7.12 Nm (8 Ibf.in) Max
Polarity LED
Figure 21: Power Entry Module
The Power Entry Modules are numbered from 1 on the left to 4 on the right of
the rear view of the subrack chassis.
3BK 21281 AAAA PCZZA Ed.13
57 / 90
To Next Page
Loading...
