4 Maintain the LIU Subrack
4.3.2 Insert JBXPEM
Before inserting the new JBXPEM check the new board ICS.
Depending on new board ICS apply the appropriate case:
Insert JBXPEM in Case of ICS 01 (Section 4.3.2.1)
Insert JBXPEM in Case of ICS 02 or Newer (Section 4.3.2.2).
4.3.2.1 Insert JBXPEM in Case of ICS 01
To insert the LIU PEM:
1. Connect the power cable to the board.
2. Insert using handle the board with the power cable attached into the shelf
until you feel resistance.
3. Fasten the top screw with the screwdriver.
4. Fasten the bottom screw with the screwdriver.
The bottom screw is located under the handle.
5. Switch ON the corresponding breaker on PDU.
4.3.2.2 Insert JBXPEM in Case of ICS 02 or Newer
To insert the LIU PEM:
1. Partially insert the board into slot rails, back connectors are not reached yet.
2. Connect the power cable to the board.
3. Switch ON the corresponding breaker on PDU.
4. Insert using handle the board with the power cable attached into the shelf
until you feel resistance.
5. Fasten the top screw with the screwdriver.
6. Fasten the bottom screw with the screwdriver.
The bottom screw is located under the handle.
66 / 90
3BK 21281 AAAA PCZZA Ed.13
To Next Page
Loading...
