6 Software Procedures
6.4.8 Wait enough time for trace dumped to disk
In this step of the script sleeps for 1 minute, and prints the following message:
Waiting remaining trace to be saved to disk ..
Because, we can not get information from TRF Master, we do not know
when previous step can be stopped. So we have to wait enough time before
copying the files.
6.4.9 Get trace files from CCP boards
In this step of the script triggers the file transfer from CCP & TP boards to active
OMCP board. It will remotely trigger script script_tra_store.pl on all CCP &
TP boards. It waits until script_tra_store.pl on all boards stopped. Using of
rsh is needed to do remote commands.
6.4.10 Clean secure disk space & move required trace data into it on
both OMCP
In this step of the script removes the previous secured data. This step is
executed on both OMCP board simultaneously . Before this step, the operator
can stop the script without any impact on the secured data. But after this
step, the secured folder is emptied.
In this step, the script first erases all data in the secured folder
/var/log/secured. Next it saves the BSC version, MXPF version and Patch
names into one file /var/log/secured/BSC-General.txt.
Next, the script moves all the trace data listed in Tool collecting On-Demand
Traces/Logs (Section 6.4)to the secured folder. For all these data, we
also have to filter the trace/log files based on the begin/end time inputed
in step 6.4.2. If telecom trace collected, the latest collected trace are also
moved. For the unmerged files, they need to be copy to a separate folder
/var/log/secured/xxx/nomerged/. This is to speed up the trace collection.
So when restored, the data in the nomerged folder do not need to be moved
back.
6.4.11 File Transfer to 9153 OMC-R
For 9153 OMC-R file transfer, due to 9153 OMC-R security policy, the collecting
is done on 9153 OMC-R and put into /alcatel/var/maintenance/failure/
directory from /var/log/secured/ directory on 9130 BSC Evolution.
1. At the UNIX command prompt, enter
gftp
The gftp window opens.
2. Input the IP address of 9130 BSC Evolution
3. Input the user: mxadmin and corresponding password
4. Input the port: 22
5. Conect to 9130 BSC Evolution
6. You can transfer files by:
Double clicking on the required file. It will be added to the transfer queue
and the transfer start automatically
Dragging the files from one side and dropping them on the other side.
90 / 90 3BK 21281 AAAA PCZZA Ed.13
To Previous Page
Loading...
