Alcatel-Lucent 9130 BSC Evolution - Figure 15: Extraction of Front Fillers; Remove; Insert JBXFILL

3 Maintain the ATCA Subrack
3.5.6 Remove / Insert JBXFILL
Unused slots (front and rear) must be equipped with fillers.
The ATCA front fillers are used to create the appropriate air flow within the
subrack.
3.5.6.1 Remove JBXFILL
To remove the ATCA front filler (JBXFILL):
1. Unfasten screws of front plate until board is detached from the shelf.
2. Remove the JBXFILL from the shelf.
Note: Fillers do not have handles. Use a metallic blade or a flat head screwdriver for
extracting fillers, as shown in the following figure.
Figure 15: Extraction of Front Fillers
3.5.6.2 Insert JBXFILL
To insert the ATCA front filler (JBXFILL):
1. Slide the JBXFILL into the shelf until you feel resistance.
2. Tighten the front plate screws which secure the board to the shelf .
46 / 90
3BK 21281 AAAA PCZZA Ed.13