3 Maintain the ATCA Subrack
x is 30 for JBXOMCP1
x is 40 for JBXOMCP2.
16. Configure the VLAN of the new JBXSSW
root@OMCP_x:~# cd /root
root@OMCP_x:./mx_setVlan -fs SSWx
where:
x is 1, if SSW1 was replaced
x is 2, if SSW2 was replaced.
17. The VLAN configuration is finished when the following message is displayed
SSWx F300 Vlan configuration done and persisted.
VLAN configuration is also displayed.
18. Close the terminal window.
19. Connect all the cables to the JAXSSW in the initial position.
3BK 21281 AAAA PCZZA Ed.13
45 / 90
To Next Page
Loading...
