3 Maintain the ATCA Subrack
3.5.4 Replace JBXCCP
3.5.4.1 Remove JBXCCP
To remove a JBXCCP board:
1. Identify the board to be replaced. Refer to Board/Area/Slot/SBL Mapping
(Section 1.3) for details.
2. Unfasten screws of front plate until board is detached from shelf
3. Lock the JBXCCP if it is the active one
Wait until the blue LED is illuminated permanently.
4. Move the ejector handles outwards
5. Remove board from shelf.
3.5.4.2 Insert JBXCCP
To insert a JBXCCP board:
1. Ensure that the top and bottom ejector handles are in the outward position
2. Insert board into the shelf by placing the top and bottom edges of the board
in the card guides of the shelf. Ensure that the guiding module of shelf
and board are aligned properly.
3. Slide the board into the shelf until you feel resistance
4. Wait until the blue LED is illuminated
5. Simultaneously move the top and bottom ejector handles to the inward
position to lock the board to the shelf
6. Unlock the JBXCCP board.
7. Wait until the blue LED is switched OFF
8. The switched OFF blue LED indicates that the board is active
9. Tighten the front plate screws which secure the board to the shelf.
3BK 21281 AAAA PCZZA Ed.13
41 / 90
To Next Page
Loading...
