Alcatel-Lucent 9130 BSC Evolution - Page 83

6 Software Procedures
6.3.1.3 Parameters in 9130 BSC Evolution
The table below lists the parameters used to assign the external IP addresses
to the 9130 BSC Evolution usign the BSC terminal.
Parameter Name Purpose
Comments
General Parameters
IP_Ethernet_Topology Indicates whether a one-LAN or two-LAN
solution is used
Possible value:
One-LAN
Two-LAN
Default value: two-LAN
Extraction_Point Indicates whether the O&M traffic goes over
MLPPP on Ater interface
Default value: Direct
For Subnet A
Subnet_Mask_A Gives the mask of the MxBSC external
subnet A
Default value: A1/24
Start_OAM_IP_Addr_A Defines the starting O&M IP address in
Subnet A
Default value: NA
For Subnet B
Subnet_Mask_B Gives the mask of the MxBSC external
subnets B
Default value: B/24
Start_IP_Addr_B Defines the starting IP address in Subnet B Default value: NA
For Subnet C
Subnet_Mask_C Gives the mask of the MxBSC external
subnets C
Default value: C/24
Start_IP_Addr_C Defines the starting IP address in Subnet C Default value: NA
Static routes
Gateway_IP_Addr_B Defines the IP address of the gateway in
Subnet B
Default value: NA
Required in the two-LAN solution
Gateway_IP_Addr_C Defines the IP address of the gateway in
Subnet C
Default value: NA.
Required in the two-LAN solution.
3BK 21281 AAAA PCZZA Ed.13 83 / 90