Power over Ethernet Defaults Managing Power over Ethernet (PoE)
page 5-4 OmniSwitch 6860 Hardware Users Guide May 2014
Viewing PoE Status
To view current PoE status and settings, use the show lanpower slot command:
-> show lanpower slot 1/1
Port Maximum(mW) Actual Used(mW) Status Priority On/Off Class Type
----+-----------+---------------+-----------+---------+--------+-------+----------
1 60000 0 Powered Off Low OFF .
2 60000 0 Powered Off Low OFF .
3 60000 0 Powered Off Low OFF .
4 60000 0 Powered Off Low OFF .
5 30000 0 Powered Off Low OFF .
6 30000 0 Powered Off Low OFF .
7 30000 0 Powered Off Low OFF .
8 30000 0 Powered Off Low OFF .
9 30000 0 Powered Off Low OFF .
10 30000 0 Powered Off Low OFF .
...
45 30000 0 Powered Off Low OFF .
46 30000 0 Powered Off Low OFF .
47 30000 0 Powered Off Low OFF .
48 30000 0 Powered Off Low OFF .
ChassisId 1 Slot 1 Max Watts 780
0 Watts Total Power Budget Used
780 Watts Total Power Budget Available
1 Power Supplies Available
BPS power: Not Available
Power over Ethernet Defaults
The following table lists the defaults for PoE configuration:
Parameter Description Command(s) Default Value/Comments
PoE operational status lanpower slot service Disabled
Total power available to a port lanpower power OS6860 models: 30000 milli-
watts on all ports
OS6860E (Enhanced) models:
60000 milliwatts on ports 1
through 4; 30000 milliwatts on
ports 5 and higher
Total power available to an
entire slot
lanpower slot maxpower 920W power supply- 780W
600W power supply - 450W
Power priority level for a port lanpower priority low
Capacitor detection method lanpower capacitor-detection Disabled
Priority disconnect status lanpower slot priority-disconnect Enabled
To Next Page
Loading...
