OmniSwitch BPS Power Connections OmniSwitch Backup Power Shelf/System (BPS)
page 4-18 OmniSwitch 6860 Hardware Users Guide May 2014
OmniSwitch BPS Power Connections
Connecting the OmniSwitch BPS to OS6860 Switches
System power is provided to each OS6860 through a single one meter DB25 connector cable. Up to eight
switches may be connected to the OmniSwitch BPS chassis. To connect a switch to the
OS-BPS chassis, follow the steps below.
1 Attach one end of the cable to the DB25 connector on the rear of the OS-BPS.
2 Next, attach the other end of the cable to the DB25 connector on the rear of the switch chassis.
Note. When connecting virtual chassis to the OS-BPS, note that the switch connected to connector port
“C1” will have the highest power budget priority; the switch connected to connector port “C2” will have
the next highest priority, etc. For additional information, refer to “OS-BPS Connector Priority” on
page 4-6 for more information.
OS6860 DB25 Connector
OmniSwitch BPS DB25 Connector
1 Meter Connector Cable
To Next Page
Loading...
