Alcatel-Lucent OmniSwitch 6860E - Power over Ethernet Specifications

Managing Power over Ethernet (PoE) Power over Ethernet Specifications
OmniSwitch 6860 Hardware Users Guide May 2014 page 5-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to Chapter 3, “Chassis and
Power Supplies.”
Viewing Power Supply Status
To view the type and status for installed power supplies, use the show powersupply command:
-> show powersupply
Total PS
Chassis/PS Power Type Status Location
-----------+---------+--------+--------+-----------
1/1 920 AC UP Internal
Total 920
IEEE Standards supported
IEEE 802.3; 802.af; 802.3at
PoE Class Detection Supported
Default PoE administrative status Enabled
Default PoE operational status Disabled (PoE must be activated on a slot-by-
slot basis via the lanpower slot service
command.)
Platforms supporting PoE OS6860-P24; OS6860-P48; OS6860E-P24;
OS6860E-P48
Default inline power per port OS6860 models: 30000 milliwatts on all ports
OS6860E (Enhanced) models: 60000 milliwatts
on ports 1 through 4; 30000 milliwatts on ports
5 and higher
Range of inline power per port OS6860 models: 3000-30000 milliwatts on all
ports
OS6860E (Enhanced) models: 3000-60000
milliwatts on ports 1 through 4; 3000-30000
milliwatts on ports 5 and higher
Default PoE power per slot 920W power supply- 780W
600W power supply - 450W
Maximum PoE power per slot 920W power supply- 780W
600W power supply - 450W