OmniSwitch Backup Power Shelf/System (BPS) Disconnecting a Chassis from the OS-BPS
OmniSwitch 6860 Hardware Users Guide May 2014 page 4-25
Removing PoE Power Supplies
1 When removing a power supply, first disconnect the power cord from the power source. Once the
power cord is disconnected, pull the power cord out of the power supply housing.
2 Pressing the lock tab toward the right, as shown, will free the lever. Pull the lever to release the power
supply from chassis, pull the power supply straight back and out of the chassis slot.
Note. If you are not replacing the power supply, be sure to install a blank cover panel over the empty
power supply bay.
To Next Page
Loading...
