Mounting the Switch Chassis and Power Supplies
page 3-22 OmniSwitch 6860 Hardware Users Guide May 2014
Airflow Recommendations
To ensure proper airflow, be sure that your switch is placed in a well-ventilated area and provide minimum
recommended clearance at the front, back and sides of the switch, as shown below. Restricted airflow can
cause your switch to overheat, which can lead to switch failure. Refer to the following important
guidelines regarding airflow:
Follow the guidelines below regarding the minimum clearance requirements when mounting
the chassis.
Chassis Top View
Note. Clearance is not required at the top and bottom of the chassis.
}
}
Rear. 6 inches minimum
at rear of chassis.
Front. 6 inches minimum
at front of chassis.
Sides. 2 inches minimum
at left and right sides.
To Next Page
Loading...
