INTRODUCTION CHAPTER 1
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
8
set IPaddress = xxx.xxx.xxx.xxx
set Netmask = xxx.xxx.xxx.xxx
set Gateway = xxx.xxx.xxx.xxx (optional)
set DNS = xxx.xxx.xxx.xxx (optional)
As each value is accepted, the reader replies with the accepted value.
7. Type “
Reboot” to reboot the reader and apply the new network settings.
The network settings can be immediately applied in the ALR-9800 by using
the "NetworkReset" command. This causes the network interfaces to be shut
down and restarted with the new settings. Note that both the "Reboot" and
"NetworkReset" commands will drop any active TCP/IP connections.
To Next Page
Loading...