To Next Page

To Previous Page

ALIEN READER PROTOCOL CHAPTER 4

READER INTERFACE GUIDE

DOC. CONTROL # 8101938-000 REV 05

<Alien-RFID-Tag-List>

<Alien-RFID-Tag>

<Protocol>Class 0</Protocol>

</Alien-RFID-Tag>

<Alien-RFID-Tag>

<Protocol>Class 1 Gen 1</Protocol>

</Alien-RFID-Tag>

<Alien-RFID-Tag>

<Protocol>Class 1 Gen 2</Protocol>

</Alien-RFID-Tag>

</Alien-RFID-Tag-List>

In all cases the following information is reported per tag:

 TagID: the 64-bit or 96-bit tag ID.

 Disc: the time the tag was first read by the reader in the current session.

 Last: the most recent time the tag was read by the reader in the current

session.

 Count: the number of times the tag has been read in the current session.

 Ant: the antenna port number where the tag was LAST seen. Since the

ALR-9800 uses separate transmit and receive antennas, the reported

antenna is the transmit antenna.

TagListFormat Examples

Command

Response

>get TagListFormat

TagListFormat = Text

Command

Response

>set TagListFormat = XML

TagListFormat = XML

TagListCustomFormat

9800 | 9780 | 8780 | 9640 | 9774

The TagListCustomFormat command allows a customized TagList to be defined.

Once the format has been defined it can be applied by issuing the command

set TagListFormat = Custom

The TagListCustomFormat command takes a single text line argument that

defines how each tag should be represented on-screen. This argument can be

made up of a mixture of text and tokens, as defined in the table below. The

maximum length of a custom TagList format definition is 255 characters.

Alien Technology ALR-9800 User Manual

Questions and Answers: