Alien Technology ALR-9800 User Manual

READERHOST PROTOCOL CHAPTER 4
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
90
 Value is automatically incremented (in a hexadecimal fashion) upon a
completion of a successful programming operation.
ProgramID Examples
Command
Response
>set ProgramID = 01 23 45 67 89 AB CD EF
ProgramID = 01 23 45 67 89 AB CD EF
Command
Response
>get ProgramID
ProgramID = 01 23 45 67 89 AB CD EF
ProgramPassCode
9800 | 9780 | 8780 | 9640 | 9774
The ProgramPassCode attribute is used in AutoMode when the AutoAction has
been set to "Program and Lock". The reader will use the value of
ProgramPassCode as the PassCode used to lock the ID after successfully
programming it.
 Value supplied must be a single byte.
 The default ProgramPassCode is 0x01.
ProgramPassCode Examples
Command
Response
>get ProgramPassCode
ProgramPassCode = 01
Command
Response
>set ProgramPassCode = FF
ProgramPassCode = FF
ProgIncrementOnFail
9800 | 9780 | 8780 | 9640 | 9774
The ProgIncrementOnFail flag is used in AutoMode when the AutoAction has
been set to "Program" or "Program and Lock". By default, the reader only
increments the ProgramID when an AutoMode cycle successfully programs a
tag. Setting ProgIncrementOnFail to "On" tells the reader to increment the
ProgramID after every AutoMode cycle.
 Allowed values are "On" or "Off.
 The default value for ProgIncrementOnFail is "Off".
ProgramIncrementOnFail Examples
Command
Response
>get ProgIncrementOnFail
ProgIncrementOnFail = OFF
Command
Response
>set ProgIncrementOnFail = On
ProgIncrementOnFail = ON

Alien Technology ALR-9800 Specifications

General

Brand	Alien Technology
Model	ALR-9800
Category	Scanner
Language	English