CHAPTER 4 ALIEN READER PROTOCOL
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
29
Command List
GENERAL COMMANDS
Command Description
9800
9780
8780
9640
9770
Help (or “h”) List all reader commands available.
✔ ✔ ✔ ✔ ✔
Info (or (“i”) List all current reader settings.
✔ ✔ ✔ ✔ ✔
! (exclamation mark) Repeats the last command issued.
✔ ✔ ✔ ✔ ✔
Save Save current settings to flash memory
✔ ✔ ✔ ✔
-
Quit ("q") Quit session (telnet only)
✔ ✔ ✔ ✔ ✔
get Function
set Function
Used to enable and disable classes of commands
(programming, for example)
✔ ✔ ✔ ✔ ✔
get ReaderName
set ReaderName
Allows an arbitrary name to be associated with and
retrieved from the reader.
✔ ✔ ✔ ✔ ✔
get ReaderType Get a description of the reader type.
✔ ✔ ✔ ✔ ✔
get ReaderVersion Get the reader software/hardware versions.
✔ ✔ ✔ ✔ ✔
get ReaderNumber
set ReaderNumber
Get and Set an arbitrary number (1-255) to be
associated with the reader.
✔ ✔ ✔ ✔ ✔
get Uptime
Returns the number of seconds that have elapsed
since the reader was last booted.
✔ ✔ ✔ ✔ ✔
get Username
set Username
Get and Set the Username used for the Network based
access control.
✔ ✔ ✔ ✔ ✔
get Password
set Password
Get and Set the Password used for the Network based
access control.
✔ ✔ ✔ ✔ ✔
get MaxAntenna
Returns the maximum addressible antenna port
number (total number of antennas is MaxAntenna+1)
✔ ✔ ✔ ✔ ✔
get AntennaSequence
set AntennaSequence
Get and Set the antenna port sequence the reader
should use.
✔ ✔ ✔ ✔ ✔
get RFAttenuation
set RFAttenuation
Get and Set the amount of digital attenuation to apply
to the emitted RF.
✔ ✔ ✔ ✔
FactorySettings Reset the reader to its original factory settings.
✔ ✔ ✔ ✔
Reboot Reboot the reader.
✔ ✔ ✔ ✔ ✔
To Next Page
Loading...
Need help?
General