CHAPTER 4 ALIEN READER PROTOCOL
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
73
AutoModeTriggerNow Examples
Command
Response
>AutoModeTriggerNow
Auto Mode Triggering Now
Notify Mode Commands
The Notify Mode commands are used to set up automated event notification
either on the expiration of a timer, or triggered off of events that occur with the
reader is running in Autonomous Mode.
NotifyMode
9800 | 9780 | 8780 | 9640 | 9774
The NotifyMode command turns on or off the notify mode.
Valid command parameters are ON and OFF.
The default setting is OFF.
NotifyMode Examples
Command
Response
>get NotifyMode
NotifyMode = ON
Command
Response
>set NotifyMode = on
NotifyMode = ON
NotifyAddress
9800 | 9780 | 8780 | 9640 | 9774
The Notify Address command pair specifies where notification messages should
be sent when they occur and how they should be sent. The form of the address
determines the method of delivery.
Currently there are 3 delivery methods supported as shown in the table below:
NotifyAddress Description
user@domain.com
Send a message via e-mail to the address specified. The
address is specified in standard email form, i.e.,
user@domain.com
NOTE: the MailServer parameter must be configured for this
to work. Optionally the MailFrom parameter can be used.
hostname:port Send a message to a specified port on a networked
machine. The address takes the form “hostname:port.” For
example, “123.01.02.98:3450” or
“listener.alientechnology.com:10002”
serial Send a message to the serial connection. The word “serial”
is used as the address. The word is not case sensitive.
To Next Page
Loading...
Need help?
General