Alien Technology ALR-9800 User Manual

CHAPTER 4 ALIEN READER PROTOCOL
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
67
AutoStartTrigger Examples
Command
Response
>get AutoStartPause
AutoStartPause = 0
Command
Response
>set AutoStartPause = 150
AutoStartPause = 150
AutoWorkOutput
9800 | 9780 | 8780 | 9640 | 9774
The AutoWorkOutput specifies the output pin settings to effect while in the work
state of Autonomous Mode. The parameter is a bitmap for the four external
output pins, where a "1" sets a pin to high, and a "0" sets a pin to low. Output pin
1 is specified by bit 0 in the mask, output pin 2 is specified by bit 1 in the mask,
etc.
AutoWorkOutput Examples
Command
Response
>get AutoWorkOutput
AutoWorkOutput =0
Command
Response
>set AutoWorkOutput =3 (sets pins 0 and 1 high)
AutoWorkOutput =3
AutoAction
9800 | 9780 | 8780 | 9640 | 9774
The AutoAction command specifies the action to perform when running in the
work mode of auto mode. This can be one of the following options:
 Acquire (default)
 None
Additional AutoAction options are available with the reader is in "Programmer"
mode (see the Function command):
 Program
 Erase
 Program and Lock
 Kill

Alien Technology ALR-9800 Specifications

General

Brand	Alien Technology
Model	ALR-9800
Category	Scanner
Language	English