EasyManuals Logo

Alien Technology ALR-9800 User Manual

Default Icon
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
ALIEN READER PROTOCOL CHAPTER 4
READER INTERFACE GUIDE
DOC. CONTROL # 8101938-000 REV 05
30
N
ETWORK CONFIGURATION COMMANDS
Command Description
9800
9780
8780
9640
9770
get MACAddress
Returns the reader's MAC (Media Access Control)
address – an identifier unique to every reader.
get DHCP
set DHCP
Turn DHCP on or off. If DHCP is on, the reader
automatically configures itself for the network on power-
up.
get IPAddress
set IPAddress
Set and Get the network ID (IP Address) of the reader.
If DHCP is enabled this will be set automatically.
get Gateway
set Gateway
Set and Get the network gateway. If DHCP is enabled
this will be set automatically.
get Netmask
set Netmask
Set and Get the subnet mask. If DHCP is enabled this
will be set automatically.
get DNS
set DNS
Set and Get the domain name server. If DHCP is
enabled this will be set automatically.
get NetworkTimeout
set NetworkTimeout
The amount of time before the reader closes a network
socket after inbound communication ceases.
get CommandPort
set CommandPort
The reader reacts to commands over the network only
if they are directed at a specific Command Port.
Ping Tests a network connection to another device.
✔✔✔✔
NetworkReset
Applies network changes immediately, without
rebooting.
get HeartbeatAddress
set HeartbeatAddress
Set and Get the IP address to deliver heartbeat
message to. The default value is 255.255.255.255
(multicast).
get HeartbeatPort
set HeartbeatPort
The reader periodically sends out heartbeat messages
to network devices on its subnet to this port.
get HeartbeatTime
set HeartbeatTime
Set and Get the time interval, in seconds, between
successive heartbeats.
get HeartbeatCount
set HeartbeatCount
Set and Get the total number of heartbeats to send out
after booting.
T
IME COMMANDS
Command Description
9800
9780
8780
9640
9770
get TimeServer
set TimeServer
Get and Set the location of a network time server.
get TimeZone
set TimeZone
Get and Set the time zone offset from UTC for the real
time clock.
get Time
set Time
Get and Set the real time clock on the reader in Local
time.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alien Technology ALR-9800 and is the answer not in the manual?

Alien Technology ALR-9800 Specifications

General IconGeneral
BrandAlien Technology
ModelALR-9800
CategoryScanner
LanguageEnglish