Align Super Combo TREX 500PRO DFC RH50E01XT - Gear and Motor Installation

[SOOFLH8AI
@ 0 •
Socl<et collar &Cnlw
(M3I20mml ~ 2
Q)
•
•
o
•
M3Nut
Soc ket collar acrew
". 3120mm
Socke t screw
.. 3 .10mm
IFor motor Ibdnll]
Set the motor pin ion gear to main dri ve gear mesh to approximately 0.1mm
to avoid e
xcess power consumption or moto r burnt due to over load .
4250 3G Carb on f lbe. bl ad e
r
M 3N ut K2
@
When fixing t ile screw 01
pinion 98ar, please aim lrl
the 1I..ln9 point on motor
sha lt.
Motor
,~~
SOOHM1 I
Aft er assembling the motor pinion gear and
main drive gear , the horizontal distance must
be within 1mm.
~
M3 set $C rew
M3dmm
M3 Sal serew
( "3 ..3mm l>.2
@ •
M 3W n he r
1 .3 • • I.lmm }x 2
@ [)III
Socket screw
( .. ,.I o.. m ). 2
A lr eady as sembled by Fac tory .
Bef ore fl
ying , please check if
the scr ews are fi xed with glue .
14
Back to the cover