Rockwell Automation Publication 1444-UM001D-EN-P - June 2018 85
Install the Dynamix 1444 Series Monitoring System Chapter 2
NPN/PNP Proximity Switch
The connected channel of the Tachometer Signal Conditioner must be
configured with:
• Transducer Type = NPN Proximity Switch, or
• Transducer Type = PNP Proximity Switch, and
Transducer Power = 24V DC
Wire the proximity switch as illustrated.
Figure 34 - Channel 0 Wiring for an NPN/PNP Proximity Switch
* Shield can be landed to any available shield connection. See the IMPORTANT note on page 56 for additional information.
Figure 35 - Channel 1 Wiring for an NPN/PNP Proximity Switch
* Shield can be landed to any available shield connection. See the IMPORTANT note on page 56 for additional information.
Shield Floating
Common
Signal
Shield
24V DC
3
1
7*
2
24 19
18
13
1
6
712
1
72
3
Shield Floating
Common
Signal
Shield
24V DC
6
4
5
10*
4
10
5
6
1
6
7
12
24 19
18
13
To Next Page
Loading...