Allen-Bradley DeviceNet 1756-DNB - Communication Module

3–5Configuring Through DeviceNet Manager Software
Publication 1756–6.5.15 – July 1998
You see a screen similar to this one.
You will only see the Network button if your PC is
connected to a network.
Select the file you wish to load and choose OK.
C. To load module defaults for your communication module, in
the Load From field, choose Module Defaults.
With step C, the Module Configuration screen is
automatically updated. The title and status bars will reflect
the change.
From title bar
From status bar
4. From the Access drop list, choose the means by which DeviceNet
Manager software will access the network for configuring your
communication module.
Currently the DeviceNet network is the only selection available.
5. Save your data:
To In this Field Choose
Save data to your communication module’s
non-volatile memory
1
Save to DNB
Save data to a file in your pc Save to File
1
This induces a flash-memory update; the communication module must be in idle mode.
Allen-Bradley Drives