Rockwell Automation Publication 6000-TG100A-EN-P - September 2020 57
Chapter 5 Isolation Transformer Cabinet
Figure 11 - Exploded view of the HECS and Mounting Bracket for B-Frame
5. Install the HECS on the Mounting Bracket using the existing hardware.
6. Install the Mounting Bracket to the cabinet using existing hardware.
7. Reroute the power cable through the HECS and reattach to the Power
Cell.
M5 x 16 cross pan head screw
M6 nut
Ø5 washer
M5 nut
Ø6 washer
ATTENTION: Verify that the current sampling direction is correct. This is
indicated by an arrow symbol on the top of the HECS.
To Next Page
Loading...
