Preliminary Information
About the Control
The control on the machine is an advanced, graphical, program-
mable computer that lets the owner control most machine fea-
tures by interacting with the control.
This control allows the owner to program custom cycles, run di-
agnostic cycles and retrieve audit and error information.
Machines shipped from the factory have default cycles built in.
The owner can change the default cycles or any cycle.
IMPORTANT: It is extremely important that the machine
has a positive ground and that all mechanical and elec-
trical connections are made before applying power to
or operating the machine.
Power Failure Recovery
If a cycle is in progress when the power fails, and if the power
outage lasts five (5) or more seconds, the cycle is lost and cannot
be resumed when power recovers. If the power outage lasts less
than five (5) seconds, the control will resume the cycle when the
power recovers.
IR Communications
The control has the ability to communicate with a PDA or PC
with an IrDA device running the control software. Devices such
as PDAs and PCs that are IrDA capable (able to transmit infor-
mation to machine) that have been tested and approved for use
with the control software can be used as a tool for managing the
machine.
IR Communications Error
Figure 2
The IR Communications Error Menu displays after the control
had an error communicating with a PC/PDA. The control will re-
turn to previous page.
IR Communications Menu
Figure 3
The IR Communications Menu displays while the control is com-
municating with a PC/PDA. The control will jump back to the
previous page when the communication is complete.
USB Communications
The control has the ability to program and audit with a PC using
a USB connection between the control and a USB adapter don-
gle.
Network Communications
For certain models, the control has the ability to communicate
through a network. The network link allows the user to program,
collect data, and run diagnostics on any machine in the network
from a central location.
Audit Information
The control collects and stores audit information which can be
accessed with key presses, IR and USB communication or
through the network. Refer to Audit Data Menu for a list of avail-
able audit information.
Error Status Indicator
If the control recognizes an error, the Error Status Indicator will
be shown in the upper left corner of the display. Refer to Figure
4 . The Error Status Indicator is displayable from any menu.
Preliminary Information
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
15 Part No. 70549501ENR6
To Next Page
Loading...
