Machine Cycle Definition and Operation
The control comes programmed with 41 machine cycles with the
ability to enable up to 48 cycles. The user can modify machine
cycles or set them to enabled or disabled by manually editing
them in Modify Cycle Menu, or through IR communication or the
network by downloading a modified machine cycle into the con-
trol. Machine cycles cannot be deleted, but can be made “unavail-
able” so that they are not visible from the Cycle Selection Menu.
New machine cycles cannot be created, but existing machine cy-
cles that have been edited to be “unavailable” may be re-edited to
be available again.
Machine Cycle Operation
When a cycle is run, the control runs the cycle step by step in a
sequence. First the control examines the Cycle Type chosen to
determine if it is a Time Dry, Auto-Dry or Moisture Dry cycle
type. Then the first step is examined to see if it is programmed to
on or off. If the step is programmed to off, control skips to the
next step.
At the start of some machine cycles, the control displays a Total
Remaining Cycle time. This time is taken from the machine cy-
cles as they are programmed. The Total Remaining Cycle Time
begins to count down as soon as the cycle is started.
Time Dry Cycle
In this type of cycle, the control will regulate the temperature and
time duration as programmed for the cycle chosen.
Auto Dry Cycle
If this type of cycle is selected, the control determines the cycle
time based on the temperature and dryness level programmed for
the cycle chosen.
Moisture Dry Cycle (if equipped)
In this type of cycle, the control checks the programmed material
type, programmed target moisture content, programmed tempera-
ture and the size/type of machine.
Start a Cycle
1. While in Start Mode, press the or keypad to scroll
through the cycle list in the Cycle Selection Menu.
2.
Press the keypad to start the highlighted cycle.
NOTE: If door is not closed when the keypad is
pressed, display will show the Close Door Menu.
Every night at midnight the control enters the Service Schedule
Menu if the machine is in Start Mode on the Cycle Selection
Menu.
When a keypad is pressed or the door is opened or an IR commu-
nication takes place, the control turns the backlight back on (if
programmed, refer to Globals Menu).
The control also enters a specific service sub-menu for that day.
The Monthly Menu displays on the first day of the month. The
Yearly Menu displays on the first day of the year. The Daily
Menu displays on all other days.
Press any keypad to clear the menu and enter Cycle Selection
Menu.
Optional settings are performed by additional keypad presses:
•
Press the keypad to enter the System Menu.
• Press the keypad to enter the Cycle Options Menu.
Cycle Selection Menu
Figure 6
Upon power-up, press the keypad to enter the Cycle Selection
Menu. The Cycle Selection Menu allows the user to select one
(1) of the 48 machine cycles. Machine cycles that are set to "un-
available" are not displayed in the Cycle Selection Menu. By de-
fault, the last run cycle displays in the highlighted position. The
factory default cycle is Cycle 1.
Machine Cycle Definition and Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
20 Part No. 70549501ENR6
To Next Page
Loading...
