Manual Cycle Programming
Modify an existing or copied cycle
1. Press the and keypads to highlight the cycle to be modi-
fied.
Figure 22
2.
Press the keypad to select the cycle. The control enters the
Modify Cycle Menu.
NOTE: To copy the selected cycle, navigate to "Copy
Cycle" and press the keypad. The text will change to
"Cycle Copied".
NOTE: To advance to the next available cycle, navigate
to "Go to Next Cycle" and press the keypad.
3. Press the and keypads to highlight the step to be modi-
fied.
Figure 23
4.
Press the keypad to select the step. The control enters the
Modify Cycle Step Menu.
5. Press the and keypads to navigate between the step pa-
rameters.
Figure 24
6. Press the and keypads to change the highlighted parame-
ter.
Figure 25
7.
Press the keypad to set the parameter changes and advance
to the next step. When advancing to the next step, the changes
to the previous step are saved.
Modify Cycle Menu
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
33 Part No. 70549501ENR6
To Next Page
Loading...
