Alliance Laundry Systems UTF75N - Individual Diagnostic Tests Menu

Step Test Cycle Step Display Description
17 10 Minute Test Cycle "10 Minute Test Cycle", "Temp
Setpoint", "Time: xx:xx",
"Temperature: XXXY"
Determines if tumble dryer can
function in a cycle for 10 mi-
nutes. The control will prompt
the user to press Start to run the
cycle. While this 10 Minute
Test Cycle is running, the Start
pad may be used to decrement
the remaining cycle time. If
power to the control is turned
off before this test cycle has
ended, the cycle is cleared.
When the control is powered
back up, it will be reset to Start
Mode. Display shows “Temper-
ature: XXXY”, where XX is
the temperature and Y is the
units (Celsius or Fahrenheit).
Left or right arrows may be
used to change the temp set-
point. Up or down arrows may
be used to change time remain-
ing.
18 Power Down "Power down the machine" This is the final step of factory
test. The control will display
“Power down the machine” to
signify that factory test has
been completed and that the
user can safely unplug the ma-
chine.
Table 11
Individual Diagnostic Tests Menu
Figure 34
The Individual Test Menu allows the user to perform individual
manual diagnostic tests.
Diagnostics Menu
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
44 Part No. 70549501ENR6