Modify a Cycle While Running
Figure 20
1. Press the or keypad to scroll through the menu options
until the desired cycle parameter is highlighted.
2.
Press keypad to enter select the cycle parameter to change
the values.
3. Press the keypad to decrease the value or the keypad to
increase the value. Refer to Table 2 for possible values.
4.
Press
keypad to enter to apply new values to the running
cycle.
Parameter Value
Temp 70-190°F or C
Moisture* 0, 1, 3, 5, 7, 10-40% (by 5%
increments)
Dryness* -5, -4, -3, -2, -1, 0, +1, +2, +3,
+4, +5
Time* 1-99 (Heat), 1-240 (No Heat)
*Either Dryness, Moisture or Time appears
Table 2
I/O Menu
The I/O Menu in the Advanced Info Menu shows the current state
of all control outputs. To manipulate machine outputs, the user
must access the Inputs/Outputs Menu from the Diagnostics
Menu.
Figure 21
1. To access from the Advanced Info Menu, press the or key-
pad to scroll through the Advanced Info Menu list until I/O is
highlighted.
2.
Press keypad to display Inputs Outputs Menu.
Refer to Table 10 for menu definitions.
Advanced Info Menu
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
31 Part No. 70549501ENR6
To Next Page
Loading...
