malletKAT User Manual (ver.07-17-18)
On the second line of the display, you can change the MIDI Channel for the “k” pad number that is visible. Every
pad on the malletKAT can be assigned to any of the 16 MIDI channels separately.
By default, all pads of a Reassignment Layer are initially set to MIDI Channel 1.
Therefore, if you are
intending to COMBINE this Layer with User Setup’s Controller 1, then Controller 1 should be set to a different
MIDI channel.
REASSIGN MINIMUM VELOCITY
REASSIGN MAXIMUM VELOCITY
REASSIGN GATE TIME
Each Reassignment Layer Receives one MINIMUM, one MAXIMUM and one GATE TIME setting. This setting is
for the entire Reassignment Layer, not for the one MIDI note number.
Kit Auxiliary Reassignment Settings:
A Reassignment layer is assigned to a User Kit through the Kit Auxiliary screens.
Because of the flexibility that a Reassignment layer requires, there are FOUR screens used:
Kit Auxiliary Shortcut #29-30
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
REASSIGNMENT MODE
Parameters = OFF, COMBINE, REPLACE
The Reassignment Mode can be turned OFF (malletKAT plays the normal Controller One and Controller Two
data). It can be set to COMBINE, which then plays the notes assigned to the Reassignment Group number along
with the data from Controllers One and Two.
When the Reassignment Mode is set to REPLACE, the KIT plays the Reassignment Groups MIDI note numbers
instead of Controller One and Two.
REASSIGNMENT POLYPHONY SETTING
Parameters = Monophonic, Polyphonic
This determines whether the Reassignment Group plays in Monophonic or Polyphonic mode.
61 / 109
To Next Page
Loading...
