malletKAT User Manual (ver.07-17-18)
1. Linear Curve – natural playing curve
2. Accent Curve – stays low longer, then jumps to higher velocities
3. Cross-Fade Reverse Curve – starts loud and “fades out” at mid range. Use with User Kit “Double Mode”
on Controller 1 to crossfade to Controller 2.
4. Cross Fade Forward Curve – starts soft and “fades in” at mid range. Use with User Kit “Double Mode” on
Controller 1 to crossfade to Controller 2.
5. Cross-Switch Reverse Curve. Loud on soft hits, silent on hard hits. Use with User Kit “Double Mode” on
Controller 1 to quickly shift to Controller 2.
6. Cross-Switch Reverse Curve. Silent on soft hits, Loud on hard hits. Use with User Kit “Double Mode” on
Controller 2 to quickly shift to Controller 1.
7. Quasi-Linear Curve. Reverse of Curve 2
8.
Effective curve for Foot Controller Pedals.
VOLUME SETTING =B (highest octave) Range 00-127 This setting determines the overall volume of a patch on
your sound source. When you enter a KIT SETUP, the volume command is sent to your synth. This acts like a
MIDI Mixer, so you can control the volume of sound from patch to patch.
The volume will be overridden by the Foot Controllers if you are using them to control volume.
PROGRAM CHANGE SETTING =C (highest octave) Range 00-127 This setting selects a sound or set of sounds
on your sound source in conjunction with the BANK SELECT # command found in the KIT AUX SCREENS #3
and 4. There are usually 128 sounds in a BANK. This screen sends a program change within the Bank selected.
See the section Understanding External Synthesizer Program Changes(https://alternatemode.com/online-
docs/malletkat/#understanding-external-synthesizers)
for more information.
MIDDLE OCTAVE
77 / 109
To Next Page
Loading...
