malletKAT User Manual (ver.07-17-18)
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
DEBOUNCE COUNT
Parameters = 01-120
Debounce time is the time immediately after a hit has been recognized, where the malletKAT PRO ignores the
signal from the pad as that signal settles down. Too short of a debounce time may result in notes double
triggering on one hit. Too long of a debounce time may result in fast double strokes being missed.
DEAD STROKE COUNT
Increasing the value adds a delay time before the Dead Stroke Sounds.
Global Auxiliary Shortcut #65
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
FINE TUNING ROUTING
Parameters = Both Int & Ext, Neither, External MIDI only, Internal Only.
This function routes a FINE TUNING command to the external sound source, or for the sound source built into the
malletKAT PRO. Note that not all sound modules respond to this command. Fine Tuning of the sound source is
performed on screen # 42 “Tune Instruments to 440” page.
The following Global Screens are described in the Setting Up the Sustain Pedal
Inputs(https://alternatemode.com/online-docs/malletkat/#setting-up-the-pedal-inputs)
Section
FOOT CONTROL ONE PERFORMS
FOOT CONTROL TWO PERFORMS
FOOTSWITCH MIDI NOTES.
The following Global Screens are described in the Using the Metronome in “Groove
Mode”(https://alternatemode.com/online-docs/malletkat/#using-the-metronome-in-groove-mode)
Section
GROOVE PATTERN
GROOVE ENABLE
GROOVE ROUTING
GROOVE TEMPO
GROOVE VOLUME
87 / 109
To Next Page
Loading...
