Alto-Shaam AR-7T

Installation
18 MN-39404 • Rev 0 • 05/18 • AR-7T Series Electric Rotisserie Manual
Liing Instructions
Remove banding before liing the oven. Only li the
oven from the front.
Adjust the forks to avoid damaging the components
beneath the oven. Note that the control side of the oven
is the heaviest portion of the oven. Li the oven just
high enough to remove the wooden pallet. Lower the
oven to no more than 2" (50mm) above the oor. Secure
any hoses and dangling cords to avoid tangling or
damage. Drive slowly while moving the oven, and keep
the oven low to the ground.
®
CAUTION
Appliance and accessories may be
heavy. To prevent serious injury, always
use a su icient number of trained and
experienced workers when moving or
leveling appliance and handling accessories.
WARNING
To prevent serious injury, death, or property damage:
• Always keep appliance on top of a pallet when using a
fork li or a pallet li truck to move appliance.
• Always use a su icient number of trained and
experienced workers to place the appliance on floor,
stand, or counter.
Installation Requirements
To ensure proper operation, the installation of this
oven must be completed by qualied technicians in
accordance with the instructions provided in this
manual. Failure to follow the instructions provided
may result in damage to the oven, property, or cause
personal injury to personnel.
NOTICE: To prevent property damage:
Check the dimensions of the doorways and
aisles before attempting to move the oven
and pallet to the installation site.
Do not tilt the oven. Transport the oven in
an upright and level position only.
AR-7T
Net 361 lb (164 kg)
Ship 440 lb (200 kg)
Crated Dimensions
L x W x H (est.)
"  "  "
(1422mm x 1143mm x 1295mm)
Weight and crated dimensions