EasyManua.ls Logo

Alto-Shaam AR-7T

Alto-Shaam AR-7T
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46 MN-39404 • Rev 0 • 05/18 • AR-7T Series Electric Rotisserie Manual
Cleaning and Preventative Maintenance
How to descale the oven
NOTICE: Alto-Shaam ScaleFree Descaling Powder
(CE-27889) must be used to descale the oven.
Read and follow all safety precautions on the
descaling powder container.
1. Run a full wash cycle before descaling the oven. See
section titled "How to run a wash cycle" in this manual.
2. Open the oven door.
3. Slide open the oven cavity drain screen.
4. Place 7 oz. of Alto-Shaam ScaleFree Descaling Powder
into the oven cavity drain.
5. Close the drain screen.
6. Close the oven door.
7. Run a rinse cycle. See section titled "How to run a rinse
cycle" in this manual.
8. When the rinse cycle is complete, run a second
wash cycle.
How to clean the door gasket
Cleaning the door gasket on a daily basis prolongs the
life of the door gasket. The acids and related compounds
found in fat, particularly chicken fat, weakens the
composition of the gasket.
1. Allow the oven to cool.
2. Wipe the gasket with hot, soapy water.
3. Rinse the gasket surfaces by wiping with sponge and
clean warm water.
4. Leave the oven door slightly open at the end of the
production day to relieve the pressure on the door
gasket.
How to clean the door glass
Clean the oven glass with glass cleaner or distilled vinegar.
How to clean the rotisserie convection fan box
1. Push ON/OFF power switch to OFF or disconnect oven
from power source.
2. Remove the drive tube assembly and disk drive.
3. Using a athead screwdriver, ip the tabs on the fan
panel to the open position.
4. Remove the fan guard cover plate.
5. Spray Combitherm™ Cleaning Liquid inside of the fan
convection box. Allow the cleaner to soen the grease
for 10 minutes.
6. Use a plastic scouring pad to scrub any hard deposits.
7. Use a damp sponge and a plastic scouring pad to
remove any grease deposits accumulated in the area
surrounding the convection element and fan blade.
Take care to avoid bending the element or the blade.
8. Reinstall the fan panel.
9. Run a wash cycle.
Tab location

Table of Contents

Other manuals for Alto-Shaam AR-7T

Related product manuals